by ETI Staff | Jun 2, 2021 | Frequently Asked Questions, TRACON
TRACON FAQ’S – FPT-130 CAN THE UNIT INTERFACE WITH BMS? CAN IT COMMUNICATE WITH BACNET OR MODBUS? No, the FPT 130 provides a summary alarm via a dry contact relay. This relay is energized whenever the unit is powered. So, with power off the NC contact is...
by ETI Staff | May 25, 2021 | Frequently Asked Questions, NETCOM FAQs
HOW CAN I CHANGE THE PRESSURE SETTINGS ON MY NETCOM? Establish communications with the dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.9) and navigate to the configuration page. Here you can change the low pressure...
by ETI Staff | Mar 19, 2021 | NETCOM, News, Snow Switch, TRACON
Why the change? In an effort to become more streamlined and to do our part for the environment, ETI is moving to a paperless system for all of our product Data Sheets, Installation Guides and Manuals. Moving forward, all of our product lines; Snow Switch, Tracon and...
by ETI Staff | Feb 9, 2021 | Featured, TRACON
Heat Trace with Plastic Pipes Heat cable can be used on plastic pipes but the plastic’s durability and thermal properties must be considered. Plastic has approximately 125 times the thermal resistance than steel but is also more susceptible to damage from direct high...
by ETI Staff | Jan 24, 2021 | Controller, Frequently Asked Questions, Sensors, snow melting management, Snow Switch
WHY DO I HAVE A RED GFEP LIGHT ON? The GFEP indicator will come on when a ground fault occurs in one of the heater circuits. The insulating resistance of the heater cable is breaking down or the cable has been damaged allowing current to pass to ground thru an...
