How can I change the pressure settings on my NETCOM?

How can I change the pressure settings on my NETCOM? Establish communications with the dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.2) and navigate to the configuration page. Here you can change the low pressure alarm,...

How can I communicate with my dehydrator?

The NETCOM dehydrator can communicate via Ethernet, RS422, and RS232. The Ethernet interface provides the best communications and control of the dehydrator by providing a web based interface. Through this interface, you can monitor the system, change the IP address,...

Can I change the IP address ?

Yes, Establish communications with the dehydrator through the Ethernet interface (default IP address from the factory is 192.168.52.9) and navigate to the configuration page. Here you can change the IP address by either allowing the unit to “obtain IP address...

Can I link two dehydrators together?

By default, a NETCOM is set as a slave so that it will accept commands from any other NETCOM dehydrators that has been configured as a master. To configure a NETCOM as a master establish communications with the dehydrator through the Ethernet interface (default IP...